Adjusting The Position Of The Gear Change And Rear Brake Pedals - Ducati Monster 796 Workshop Manual

Maintenance operations
Warning
Clutch lever and front brake lever shall be adjusted when motorcycle is at a standstill.
Important
Using the clutch properly will avoid damage to transmission parts and spare the engine.
Note
The engine can be started with the side stand down and the gearbox in neutral. If starting with a gear engaged, pull in
the clutch lever (in this case the side stand must be up).

Adjusting the position of the gear change and rear brake pedals

The position of the gear change and rear brake pedals in relation to the footrests can be adjusted to suit the preferred
riding position.
To adjust the position of the gearchange pedal, proceed as follows:
hold the linkage (1) and slacken the lock nuts (2) and (3).
Note
The lock nut (2) has a left-hand thread.
Turn the tie-rod (1) using an open-ended wrench on the flats to move the gear change pedal to the required position.
Tighten both lock nuts onto the rod.
To adjust the position of the rear brake pedal, proceed as follows.
Loosen lock nut (4).
Turn the pedal travel adjustment screw (5) until the pedal is in the desired position.
Tighten the lock nut (4).