Ducati Monster 796 Workshop Manual page 311

Front brake control
Operate the front brake lever two or three times until the circuit is pressurised and force the pads against the brake disc.
Hold the lever pulled in towards the grip and tighten the calliper screws (7) to a torque of 45 Nm ± 5% (Sect. 3 - 3,
Frame torque settings).
Insert brake rubber block (D) into grommet (B) and ensure it is centred.
Fold hose clip (B) and fasten it by starting the screw (C) in its thread.
Insert hose (14) in bracket (4) and tighten screw (16) to a torque of 8 Nm ±10% (Sect. 3 - 3,
Note
For correct position of the ties fastening the ABS sensor cable (A) to front brake lines (24), please refer to Sect. 7 - 6,
Flexible wiring/hoses positioning.
Operations
Filling the braking system
Section reference
4 - 3, Filling the brake system with
fluid
Frame torque settings).