Final drive
Use wrenches (D) and (E) to turn the bolt clockwise until the punch (B) is seated against the chain plate.
To complete reassembly, repeat the entire procedure with the second pin.
Warning
Carefully check the two pins: the figure shows the correct result of the procedure.
Adjust the chain tension (Sect. 4 - 3,
Place the sprocket cover (6) tightening the screws (5) to a torque of 6 Nm ±10% (Sect. 3 - 3,
Replacing of the rear sprocket
Operations
Slacken the chain
Remove the rear wheel
Remove the circlip (18) from the nut (8).
Restrain the wheel shaft against rotation and, using a socket wrench, loosen the nut (B).
Adjusting the chain
tension).
Section reference
4 - 3,
Adjusting the chain tension
7 - 2,
Removal of the rear wheel
Frame torque
settings).