Ducati Monster 796 Workshop Manual page 315

Rear brake control
in Sect. 4 - 3, Adjusting the position of the gear change and rear brake pedals.
Refitting the rear brake control
Lubricate the O-ring (24) and install it on the pin (5).
Lubricate also the other O-ring (24).
Fit the spring (6) and the rotation pivot pin (5) to the footrest bracket, pushing the pivot pin fully home and positioning
the spring (6) as shown in the figure.
Apply threadlocker to the threads of the pivot pin (5).
Locate the line connecting rear brake master cylinder - ABS control unit (27) (796 ABS) or the pipe (3) (796) and
washers (2) on the rear brake master cylinder (17) and fix it with the special screw (1).
Note
If the hose connecting the rear master cylinder to the ABS control unit (27) and the one connecting master cylinder and
reservoir (16) are changed, ensure that the hose end fittings on master cylinder are positioned correctly.
Orientate the hoses (3) and (16) as illustrated in the figure and then tighten the screw (1) to a torque of 23 Nm ±10%
(Sect. 3 - 3, Frame torque settings).