Ducati Monster 796 Workshop Manual page 383

Fork - steering head: Steering
Grease the nut (12).
Tighten the steering shaft nut (12) by hand until it seats against the sealing ring (8).
Fit service bush no. 88713.1058 to the steering shaft nut (12) and fit the torque wrench to the bush.
Tighten the adjuster ring nut (12) to a torque of 30 Nm ±5% (Sect. 3 - 3, Frame torque settings).
Fit the steering head (2) on the steering head nut (12), aligning the fork leg bores with the corresponding bores on the
bottom yoke. Relocate the fork legs as described in Section 7 - 10,.1 Refitting the front forks.
Grease the screw (3).
Tighten the screw (3) on the steering head to a torque of 24 Nm ±5% (Sect. 3 - 3, Frame torque settings).
Refit the hose clips (27) on the steering head, starting the screws (24) in their threads with the washers (25).
Place the hose clips (27) onto the non-rotating tabs (M) and tighten the screws (24) to a torque of 8 Nm ±10% (Sect. 3 -
3, Frame torque settings).
Note
In the "ABS" version the hose clip marked with an arrow is not present.