Ducati Monster 796 Workshop Manual page 221

Instruments
Clock setting function
To set the clock, enter the menu and select the "SET" page.
Holding switch (1) pressed in position B "t" for 3 seconds in this menu page gives access to the setup mode.
On entering this mode, the message "AM" will flash; if you press switch (1) in position B "t" the message "PM" flashes; if
you press switch (1) in position B "t" the mode will go back to previous setting (if it is 00:00, when toggling from "AM" to
"PM", 12:00 will be displayed). Pressing switch (1) in position A "s" gives access to the hour setting mode; hours start to
flash. Each time you press the button in position B "t", the digit will increase by one hour. If the switch is held pressed in
position B "t" the number increases cyclically in steps of one hour every second (when the switch is held depressed, the
hours do not flash).
Pressing switch (1) in position A "s" gives access to the minute setting mode; minutes start to flash. Each time you press
the button in position B "t", the digit will increase by one minute. If you hold the switch down in position B "t", the count
increases cyclically in steps of 1 minute every second. If the button is held depressed in position B "t" for over 5 seconds,
minutes will increase by 1 minute every 100ms (while the button is held depressed in position B "t", seconds will not
flash). Pressing the button in position A "s", exits setup mode and the new time is displayed.
Note
If the power supply is disconnected (Battery-Off), the time setting is lost. When power is restored (Battery-On), the
display will show 0:00. Set the time according to the normal procedure.