Table of Contents
Advertisement
Protection and safety devices
6 -Protection and safety devices
Checking protection and safety device components
Checking the key switch
Disconnect the ignition key (A) from the electric system by opening its connection (see
Sect. 6 - 1) and use a multimeter to check continuity of its internal connections as follows:
- turn the key to OFF and connect a multimeter to contacts (1) and (4) to check electrical continuity (Sect. 6 - 13,
multimeter to check the electrical
near zero and, if present, the audible continuity signal should be emitted;
turn the key to ON and connect the multimeter to contacts (1) and (2) and then to (3) and (4) to check for electrical
continuity. The resistance reading should be near zero and, if present, the audible continuity signal should be emitted;
- turn the key to PARK and connect the multimeter to contacts (1) and (4) to check electrical continuity. The resistance
reading should be near zero and, if present, the audible continuity signal should be emitted;
- turn the key to LOCK and connect the multimeter to contacts (1) and (4) to check for electrical continuity. The resistance
reading should be near zero and, if present, the continuity sound signal should be emitted.
Note
The same test may be done using the "DDS" tester (Sect. 6 - 13,
Checking the side stand switch
Remove the switch (1) from the side stand undoing screw (2) and disconnect the main wiring connector from the switch
(see paragraph
"Routing of wiring on
Use an analogue or digital multimeter (Sect. 6 - 13,
operation (see table).
systems, concerning operation of the multimeter). The resistance reading should be
frame", Sect. 6 - 1).
Using a multimeter to check the electrical
"Routing of wiring on
DDS diagnosis
instrument).
frame",
Using a
systems) to check switch
Advertisement
Chapters
Table of Contents
