Fitting A New Exhaust Valve Motor With Used Cable - Ducati Monster 796 Workshop Manual

Maintenance operations
Press button "X" from this DDS page: the activation procedure page closes and system quits without going through test selection.
Disconnect the DDS.
Turn the key to on, let make one complete turn and make sure that the vertex of the hexagon (D) in-between the cable
mounting holes is secure/fixed next to the notch (B).
If the test result was positive in the previous step, proceed with the remaining operations. While if result was negative,
find failure cause before continuing.
Final checks
Make sure that, upon the following immediate "KEY ON" cycles, the exhaust valve stays in "fully open position", i.e. the
valve pulley rear tab must be resting against the stop plate welded to the exhaust pipe.

Fitting a new exhaust valve motor with used cable

Insert cable end coming out of the straight sheath length on motor pulley into hole (A) shown.
Insert sheath end into the relevant seat (B) on the motor.
Fit the clip to sheath terminal and make sure that it prevents cable from slipping out.