Handlebar unit: Throttle twistgrip
switches
Remove the front brake lever
Remove the clutch lever
Unscrew and remove the screws (3) securing the upper clamp (1).
Remove the upper clamp (1).
Remove the handlebar (4) from its seat on the steering head.
To remove the grips (5), refer to the exploded view at the beginning of this chapter.
Refitting the handlebar
Position and orientate the handlebar (4) so that the punch marks (A) are equidistant from the lower clamp and aligned
with the face of the clamp.
Apply the recommended grease to the threads and undersides of the heads of the screws (3).
Important
Set the upper U-bolt (1) so that arrows (B) are pointing to the tank.
Refit the upper clamp (1) and insert the screws (3).
Tighten the screws (3) to a torque of 25 Nm ±5% (Sect. 3 - 3,
as indicated in the figure.
Operations
Refit the front brake lever
devices
7 - 3,
Removal of the front brake
master cylinder
7 - 8.2,
Removal of the clutch
master cylinder assembly
Section reference
7 - 3,
Refitting the front brake
Frame torque
settings), applying the sequence 1-2-3-4-3,