Lights and indicating devices
Insert a spacer (7) to a screw (10), positioning it as indicated.
Start screw (10) in its thread on the central clip (11) of headlight cover (8).
Start the other two screws (10) in their thread on the side clips (11) of headlight cover (8).
Tighten the screws (10) to a torque of 3 Nm ±10% (Sect. 3 - 3,
Frame torque
settings).
Reconnect headlight (B) and turn indicator (E) connectors.
Reconnect the instrument panel wiring (A).
Position connector (B) onto plate (C) and the latter on the bottom yoke, fastening it with nut (2). Tighten the nuts (2) to
a torque of 10 Nm ±10% (Sect. 3 - 3,
Frame torque
settings).