Suzuki Ignis Service Manual page 2483

6-3-286 ENGINE GENERAL INFORMATION AND DIAGNOSIS (Z13DT ENGINE)
Test Table (For RB413D)
Test Work Order Description
T01 Check: Component
• Check the following component for proper operation:
Glow Plug
Yes: T02
T02 Check: Short to Ground/Interruption of Voltage Supply Circuit
• Ignition OFF
• Disconnect wiring harness connector from:
Glow Controller
• Measure voltage between the following terminals:
Glow Controller – Wiring harness connector (wiring harness side) termi-
nal E72-7
&
Ground
Yes: T03
T03 Check: Circuit Interruption of Ground Circuit
• Measure voltage between the following terminals:
Glow Controller – Wiring harness connector (wiring harness side) termi-
nal E72-7
&
Glow Controller – Wiring harness connector (wiring harness side) termi-
nal E72-6
Yes: T04
T04 Check: Interruption of Voltage Supply Circuit
• Ignition ON
• Measure voltage between the following terminals:
Glow Controller – Wiring harness connector (wiring harness side) termi-
nal E72-1
&
Ground
Yes: T05
T05 Check: Short to Voltage of Signal Circuit
• Data List Parameter
Glow Relay
Yes: T06
T06 Check: Short to Ground/Interruption of Signal Circuit
• Ignition OFF
• Connect fused jumper wire to:
Glow Controller – Wiring harness connector (wiring harness side) termi-
nal E72-3
&
Ground
• Ignition ON
• Data List Parameter
Glow Relay
Yes: T07
Nominal Value
Inspection okay?
No: E13
greater than 11 V
No: T11
greater than 11 V
No: E09
greater than 11 V
No: E08
ON
No: E07
OFF
No: E06