Radiator Sub Fan And Fan Motor - Subaru Legacy 2004 Service Manual

9. Radiator Sub Fan and Fan
Motor
A: REMOVAL
1) Set the vehicle on a lift.
2) Disconnect the ground cable from battery.
3) Lift-up the vehicle.
4) Remove the under cover.
5) Disconnect the connector (B) of sub fan motor.
6) Remove the heat shield cover. (Model without
ATF warmer)
7) Remove the ATF hose from the clip of radiator
sub fan motor assembly. (Model without ATF
warmer)
8) Lower the vehicle.
9) Remove the air intake duct. <Ref. to IN(H4SO
2.0)-9, REMOVAL, Air Intake Duct.>

Radiator Sub Fan and Fan Motor

IN-00203
(B)
CO-00275
CO-00273
CO(H4SO 2.0)-27
10) Remove the bolts which hold the radiator sub
fan shroud to radiator.
11) Remove the radiator sub fan motor assembly
from the lower side of vehicle.
B: INSTALLATION
Install in the reverse order of removal.
Tightening torque:
%
7.5 N m (0.76 kgf-m, 5.5 ft-lb)
C: DISASSEMBLY
1) Remove the clip which holds the fan motor con-
nector onto shroud.
2) Remove the nut which holds fan onto the fan
motor and shroud assembly.
COOLING
CO-00101
CO-00101
CO-00097