Subaru Legacy 2004 Service Manual page 707

24.Fuel Filler Pipe
A: REMOVAL
WARNING:
• Place "NO FIRE" signs near the working area.
• Be careful not to spill fuel on the floor.
1) Release the fuel pressure.
<Ref. to FU(H4SO 2.5)-40, RELEASING OF FUEL
PRESSURE, PROCEDURE, Fuel.>
2) Open the fuel filler flap lid, and remove the filler
cap.
3) Disconnect the ground cable from battery.
4) Remove the screws which secure the packing.
5) Lift-up the vehicle.
6) Remove the rear wheel RH.
Fuel Filler Pipe
7) Set a container under the vehicle, and remove
the drain plug from the fuel tank to drain fuel from
fuel tank.
8) Tighten the fuel drain plug.
NOTE:
Use a new gasket.
Tightening torque:
26 N
9) Remove the mud guard. <Ref. to EI-29, RE-
MOVAL, Mud Guard.>
10) Remove the rear sub frame. <Ref. to RS-23,
IN-00203
REMOVAL, Rear Sub Frame.>
11) Remove the bolts which hold the fuel filler pipe
bracket on the body.
FU-00095
12) Loosen the clamp and disconnect the fuel filler
hose (A) and vent hose (B) from fuel filler pipe.
FU-00096
13) Remove the fuel filler pipe to under side of the
vehicle.
FU(H4SO 2.5)-47
FUEL INJECTION (FUEL SYSTEMS)
!
m (2.65 kgf-m, 19.2 ft-lb)
(A)
FU-01123
FU-01139
(B)
FU-01136