Subaru Legacy 2004 Service Manual page 303

25) Apply liquid gasket to mating surfaces and in-
stall the oil separator cover.
Liquid gasket:
THREE BOND 1207C (Part No. 004403012) or
equivalent
26) Install the flywheel. (MT model)
<Ref. to CL-16, INSTALLATION, Flywheel.>
To lock the crankshaft, use the ST.
ST 498497100 CRANKSHAFT STOPPER
Tightening torque:
!
72 N m (7.3 kgf-m, 52.8 ft-lb)
27) Install the drive plate.
To lock the crankshaft, use the ST.
ST 498497100 CRANKSHAFT STOPPER
Tightening torque:
!
72 N m (7.3 kgf-m, 52.8 ft-lb)
28) Install the housing cover.
29) Installation of oil pump:
(1) Discard the front oil seal after removal. Re-
place with a new one using ST.
Cylinder Block
ME-00163
ST
ME-00297
ME-00298
ME(H4SO 2.0)-73
ST 499587100 OIL SEAL INSTALLER
(2) Apply liquid gasket to the matching surface
of oil pump.
Liquid gasket:
THREE BOND 1215 (Part No. 004403007) or
equivalent
(A) O-ring
(3) Apply a coat of engine oil to the inside of oil
seal.
(4) Install the oil pump on cylinder block. Be
careful not to damage the oil seal during instal-
lation.
Tightening torque:
!
6.4 N m (0.65 kgf-m, 4.7 ft-lb)
CAUTION:
• Do not forget to install the O-ring and seal
when installing the oil pump.
• Align the flat surface of oil pump's inner rotor
with crankshaft before installation.
30) Install the water pump and gasket.
MECHANICAL
ME-00164
(A)
ME-00165
ME-00312