Subaru Legacy 2004 Service Manual page 91

PRE-DELIVERY INSPECTION
PROCEDURE
53. Fluid leak check
54. Water leak test
55. Appearance check 2
1. APPEARANCE CHECK
• If the vehicle is covered with protective coating,
visually check the vehicle body for damage and
dents.
• When the protective coating is removed, visually
check the body paints for damage or stains in detail
and repair as necessary.
• Visually check the windshield glass, door glass-
es and light lenses for any damage, cracks or ex-
cessive gaps to the body sheet metal and repair as
necessary.
• Visually check the plated parts, such as the
grilles and door knobs, for damage or loss of gloss
and replace the parts as necessary.
2. TIRE CHECK
• Check the tires for damage, abnormal condi-
tions, and dents on the wheels.
• Check the tire size, spare tire and tire air pres-
sure described on the tire air pressure label (driv-
er's side).
3. FUSE INSTALLATION
Fuses for the back-up circuit have been removed to
prevent battery discharge. If the vehicle is about to
be delivered to the customer, attach a 20 A fuse (A)
as shown in the figure.
(A)
Pre-delivery Inspection
Check for fluid/oil leaks.
Spray the vehicle with water and check for water leaks.
(1) Remove the protective coating (if any).
(2) Check the body paints for damage and stain.
(3) Check the plated parts for damage and rust.
4. CONNECTION OF AIR CONDITIONER
HARNESS
A vehicle just delivered has its air conditioner har-
ness disconnected to protect the air conditioner
compressor. Connect the harness as shown in the
figure. (Except for 3.0 L model)
5. CHECK DOORS FOR LOCK/UNLOCK
AND OPEN/CLOSE OPERATIONS
1) Using the key, lock and unlock the door several
times to check for normal operation. Open and
close the door several times for smooth movement.
PI-00158
2) Completely close the driver's door, and then
check the smooth movement with operating door
lock knob from lock to unlock several times.
Set the door lock knob (A) to lock position. Then
pull the inner remote (B) to ensure that doors will
not open.
PI-4
Check point
(B)
(A) Unlock
(B) Lock
PI-00159
(A)
PI-00191