Subaru Legacy 2004 Service Manual page 708

FUEL INJECTION (FUEL SYSTEMS)
B: INSTALLATION
1) Open the fuel filler flap lid.
2) Set the fuel saucer (A) with rubber packing (C)
and insert the fuel filler pipe into hole from the inner
side of apron.
3) Align the holes in fuel filler pipe neck and set the
cup (B), and tighten the screws.
NOTE:
If the edges of rubber packing are folded toward the
inside, straighten it with a flat tip screwdriver.
4) Correctly insert the fuel filler hose (A) and vent
hose (B) to specified position, and then tighten the
clamp.
(A)
( 1 )
(1) Hose
(2) Clip or clamp
(3) Pipe
Fuel Filler Pipe
(A)
(B)
(C)
FU-00103
(B)
FU-01136
( 2 ) ( 3 )
L/2
L
FU-00104
FU(H4SO 2.5)-48
5) Tighten the bolts which hold the fuel filler pipe
bracket on the body.
Tightening torque:
!
7.5 N m (0.75 kgf-m, 5.4 ft-lb)
6) Install the rear sub frame. <Ref. to RS-23, IN-
STALLATION, Rear Sub Frame.>
7) Install the mud guard. <Ref. to EI-29, INSTAL-
LATION, Mud Guard.>
8) Install the rear wheel RH.
9) Lower the vehicle.
10) Install the fuse of fuel pump to main fuse box.
11) Connect the battery ground cable to battery.
FU-01139
FU-00096
IN-00203