Subaru Legacy 2004 Service Manual page 357

13) Remove the hood stay holder.
14) Remove the air intake duct. <Ref. to IN(H4SO
2.0)-9, REMOVAL, Air Intake Duct.>
15) Disconnect the radiator inlet hose from engine.
16) Remove the radiator upper brackets.
17) Lift the radiator up and away from vehicle.
B: INSTALLATION
1) Attach the radiator lower cushions to holes on
the radiator lower bracket.
2) Install the radiator to vehicle.
Radiator
NOTE:
Make pins on the lower side of radiator be fitted into
the radiator lower cushions on body side.
3) Install the radiator upper brackets and tighten
the bolts.
Tightening torque:
18 N
CO-00276
4) Connect the radiator inlet hose.
CO-00277
5) Install the air intake duct. <Ref. to IN(H4SO 2.0)-
9, INSTALLATION, Air Intake Duct.>
6) Install the hood stay holder.
CO-00278
7) Install the reservoir tank. <Ref. to CO(H4SO
2.0)-29, INSTALLATION, Reservoir Tank.>
8) Connect the over flow hose.
9) Lift-up the vehicle.
CO-00041
CO(H4SO 2.0)-21
%
m (1.8 kgf-m, 13.0 ft-lb)
COOLING
CO-00278
CO-00277
CO-00276