Subaru Legacy 2004 Service Manual page 113

PERIODIC MAINTENANCE SERVICES
2. 3.0 L MODEL
1) Replace the belts if crack, fraying or wear is
found.
2) Check that the V-belt automatic tensioner indica-
tor (A) is within the range (D).
(A)
(D)
(C)
(A) Indicator
(B) Generator
(C) Power steering oil pump
(D) Service limit
B: REPLACEMENT
1. FRONT SIDE BELT (FOR POWER
STEERING OIL PUMP AND GENERATOR)
NOTE:
Wipe off any oil and water on the belt and pulley.
1) Remove the collector cover. (If equipped)
2) Remove the V-belt covers.
• Non-turbo model
V-belt
• Turbo model
3) Loosen the lock bolt (A).
4) Loosen the slider bolt (B).
5) Remove the front side belt (C).
(B)
6) Install a new V-belt, and tighten the slider bolt so
as to obtain the specified belt tension.
7) Tighten the lock bolt (A).
8) Tighten the slider bolt (B).
Tightening torque:
ME-00475
2. REAR SIDE BELT (FOR A/C)
NOTE:
Wipe off any oil and water on the belt and pulley.
1) Remove the front side belt.
2) Loosen the lock nut (A).
3) Loosen the slider bolt (B).
4) Remove the rear side belt.
5) Install a new V-belt, and tighten the slider bolt so
as to obtain the specified belt tension.
6) Tighten the lock nut (A).
PM-00003
PM-12
Lock bolt
!
25 N m (2.5 kgf-m, 18 ft-lb)
Slider bolt
!
8 N m (0.8 kgf-m, 5.8 ft-lb)
(B)
(C)
(A)
ME-00807
PM-00004