Subaru Legacy 2004 Service Manual page 384

LUBRICATION
6) Tighten the nuts which install front cushion rub-
ber onto front crossmember.
Tightening torque:
#
69 N m (7.0 kgf-m, 50.9 ft-lb)
7) Install the front and center exhaust pipe.
<Ref. to EX(H4SO 2.0)-8, INSTALLATION, Front
Exhaust Pipe.> <Ref. to EX(H4SO 2.0)-10, IN-
STALLATION, Center Exhaust Pipe.>
8) Install the under cover.
9) Lower the vehicle.
CAUTION:
When lowing the vehicle, lower the lift-up de-
vice and wire ropes at the same time.
10) Remove the lifting device and wire ropes.
11) Install the pitching stopper.
Tightening torque:
#
T1: 50 N m (5.1 kgf-m, 36.9 ft-lb)
#
T2: 58 N m (5.9 kgf-m, 42.8 ft-lb)
T2
Oil Pan and Strainer
LU-00223
LU-00222
T1
LU-00233
LU(H4SO 2.0)-16
12) Install the hood stay holder (A) and radiator up-
per brackets (B).
(B)
13) Install the air intake chamber.
<Ref. to IN(H4SO 2.0)-8, INSTALLATION, Air In-
take Chamber.>
14) Install the air intake duct and air cleaner case.
<Ref. to IN(H4SO 2.0)-9, INSTALLATION, Air In-
take Duct.> <Ref. to IN(H4SO 2.0)-7, INSTALLA-
TION, Air Cleaner Case.>
15) Install the front wheels.
16) Connect the battery ground cable to battery.
17) Fill engine oil. <Ref. to LU(H4SO 2.0)-8, IN-
SPECTION, Engine Oil.>
C: INSPECTION
Visually check that the oil pan, oil strainer, oil
strainer stay and baffle plate are not damaged.
(B)
(A)
LU-00232
IN-00203