Subaru Legacy 2004 Service Manual page 416

STARTING/CHARGING SYSTEMS
7) Remove the plate.
(A) Plate
8) Remove the shaft assembly and overrunning
clutch from front bracket as a unit.
NOTE:
Check the following points before removal.
• Lever direction
• Position of internal gear assembly
(A) Lever
(B) Shaft ASSY
(C) Overrunning clutch
(D) Internal gear ASSY
9) Remove the overrunning clutch from shaft as-
sembly as follows:
(1) Remove the stopper from ring by lightly tap-
ping the stopper with an appropriate tool (such
as a fit socket wrench).
(A)
SC-00065
(A)
(B)
(D)
(C)
SC-00066
SC(H4SO 2.0)-8
Starter
(2) Remove the ring, stopper and clutch from
shaft.
(A) Socket wrench
(B) Ring
(C) Shaft
(D) Stopper
D: ASSEMBLY
NOTE:
Apply grease to the following parts before assem-
bly.
• Sleeve bearing
• Pinion shaft rotating part
• Shaft spline portion
• Inside of reduction system
• Lever fulcrum/Clutch rotating part
1) Install the overrunning clutch to shaft assembly.
2) Install the stopper to shaft assembly as follows.
(A)
(B)
(D)
(C)
SC-00014