Subaru Legacy 2004 Service Manual page 261

MECHANICAL
Tightening torque:
&
22 N m (2.2 kgf-m, 16 ft-lb)
(2) Connect the power steering switch connec-
tor.
(3) Install the front side belt and adjust it. <Ref.
to ME(H4SO 2.0)-38, FRONT SIDE BELT, IN-
STALLATION, V-belt.>
12) Lift-up the vehicle.
13) Tighten the nuts which hold lower side of trans-
mission to engine.
Tightening torque:
&
50 N m (5.1 kgf-m, 36.9 ft-lb)
14) Tighten the nuts which install the front cushion
rubber onto crossmember.
Tightening torque:
&
85 N m (8.7 kgf-m, 63 ft-lb)
Engine Assembly
NOTE:
Make sure the front cushion rubber mounting bolts
are securely installed.
FU-00139
15) Install the front and center exhaust pipe.
<Ref. to EX(H4SO 2.0)-8, INSTALLATION, Front
Exhaust Pipe.>
16) Lower the vehicle.
17) Connect the following hoses:
(1) Fuel delivery hose, return hose and evapo-
ration hose
(2) Heater inlet and outlet hoses
(3) Brake booster vacuum hose
18) Connect the following connectors:
(1) Front oxygen (A/F) sensor connector
FU-00878
(2) Rear oxygen sensor connector
(3) Engine ground cable
Tightening torque:
14 N
(4) Engine harness connectors
(5) Generator connector and terminal
(6) A/C compressor connector
19) Install the air intake chamber stay.
Tightening torque:
16 N
20) Install the A/C pressure hoses.
<Ref. to AC-38, INSTALLATION, Hose and Tube.>
21) Install the radiator to vehicle. <Ref. to
CO(H4SO 2.0)-21, INSTALLATION, Radiator.>
22) Install the air intake duct, air cleaner case and
air intake chamber. <Ref. to IN(H4SO 2.0)-9, IN-
STALLATION, Air Intake Duct.> <Ref. to IN(H4SO
2.0)-7, INSTALLATION, Air Cleaner Case.> <Ref.
ME-00219
to IN(H4SO 2.0)-8, INSTALLATION, Air Intake
Chamber.>
23) Install the under cover.
24) Install the battery in the vehicle, and connect
cables.
25) Fill engine coolant.
<Ref. to CO(H4SO 2.0)-13, FILLING OF ENGINE
COOLANT, REPLACEMENT, Engine Coolant.>
26) Check the ATF level and replenish it if neces-
sary.
ME(H4SO 2.0)-34
&
m (1.4 kgf-m, 10.1 ft-lb)
&
m (1.6 kgf-m, 11.6 ft-lb)
LU-00223