Subaru Legacy 2004 Service Manual page 782

ENGINE (DIAGNOSTICS)
9. Subaru Select Monitor
A: OPERATION
1. HOW TO USE SUBARU SELECT MONI-
TOR
1) Prepare the Subaru Select Monitor kit. <Ref. to
EN(H4SO 2.5)(diag)-7, PREPARATION TOOL,
General Description.>
2) Connect the diagnosis cable to Subaru Select
Monitor.
3) Insert the cartridge to Subaru Select Monitor.
<Ref. to EN(H4SO 2.5)(diag)-7, PREPARATION
TOOL, General Description.>
4) Connect the Subaru Select Monitor to data link
connector.
(1) Data link connector is located in the lower
portion of instrument panel (on the driver's side).
(2) Connect the diagnosis cable to data link
connector.
CAUTION:
Do not connect the scan tools except for Suba-
ru Select Monitor or OBD-II general scan tool.
Subaru Select Monitor
5) Turn ignition switch to ON (engine OFF) and turn
Subaru Select Monitor switch to ON.
6) Using the Subaru Select Monitor, call up DTC
and data, then record them.
2. READ DIAGNOSTIC TROUBLE CODE
(DTC) FOR ENGINE (NORMAL MODE)
EN-00038
Refer to "Read Diagnostic Trouble Code (DTC)" for
information about how to indicate DTCs. <Ref. to
EN(H4SO 2.5)(diag)-33, Read Diagnostic Trouble
Code (DTC).>
3. READ DIAGNOSTIC TROUBLE CODE
(DTC) FOR ENGINE (OBD MODE)
Refer to "Read Diagnostic Trouble Code (DTC)" for
information about how to indicate DTCs. <Ref. to
EN(H4SO 2.5)(diag)-33, Read Diagnostic Trouble
Code (DTC).>
EN-00039
EN-02533
EN(H4SO 2.5)(diag)-26
(A) Power switch
(A)
EN-00040