Subaru Legacy 2004 Service Manual page 400

IGNITION
• 2.5 L model
(4)
(1)
T2
(1) Spark plug
(2) Spark plug cord (#1, #3)
(3) Ignition coil & ignitor ASSY
C: CAUTION
• Wear work clothing, including a cap, protective
goggles, and protective shoes during operation.
• Remove contamination including dirt and corro-
sion before removal, installation or disassembly.
• Keep the disassembled parts in order and pro-
tect them from dust and dirt.
• Before removal, installation or disassembly, be
sure to clarify the failure. Avoid unnecessary re-
moval, installation, disassembly and replacement.
• Be careful not to burn yourself, because each
part on the vehicle is hot after running.
General Description
(4)
T1
(4) Spark plug cord (#2, #4)
IG(H4SO 2.0)-4
(3)
(2)
(1)
Tightening torque: N
T1: 6.4 (0.65, 4.7)
T2: 21 (2.1, 15.2)
• Be sure to tighten fasteners including bolts and
nuts to the specified torque.
• Place shop jacks or rigid racks at the specified
points.
• Before disconnecting electrical connectors of
sensors or units, be sure to disconnect the ground
cable from battery.
(2)
T2
IG-00094
#
m (kgf-m, ft-lb)