Subaru Legacy 2004 Service Manual page 297

B: INSTALLATION
(1)
(1) Crankshaft bearing
(2) Crankshaft
NOTE:
Remove oil on the mating surface of bearing and
cylinder block before installation. Apply a coat of
engine oil to crankshaft pins.
1) Position the crankshaft on the #2 and #4 cylinder
block.
2) Apply liquid gasket to the mating surface of #1
and #3 cylinder block, and position it on #2 and #4
cylinder block.
Liquid gasket:
THREE BOND 1215 (Part No. 004403007) or
equivalent
Cylinder Block
(4)
(3)
(3) Cylinder block
NOTE:
Do not allow liquid gasket to flow into O-ring
grooves, oil passages, bearing grooves, etc.
3) Tighten the 10 mm cylinder block connecting
bolts on LH side (A — D) in alphabetical sequence.
ME(H4SO 2.0)-67
(3)
(2)
(4) Rear oil seal
MECHANICAL
ME-00144
ME-00145