2) Heat portion (A) of rear cover to 50"C (122"F)
with a heater drier.
3) Then insert the tip of a flat tip screwdriver into the
gap between stator core and front cover. Pry them
apart to disassemble.
(A)
(A) Screwdriver
4) Hold the rotor with a vise and remove pulley nut.
Generator
(A)
SC-00079
(A)
SC-00080
SC-00035
SC(H4SO 2.0)-15
STARTING/CHARGING SYSTEMS
CAUTION:
When holding the rotor with a vise, place alumi-
num plates or wooden pieces on the vise jaws
to prevent rotor from damage.
(A)
(B)
(C)
(A) Front cover
(B) Pulley
(C) Nut
(D) Rotor
5) Remove the ball bearing as follows.
(1) Remove the bolt, and then remove the bear-
ing retainer.
(2) Firmly install an appropriate tool (such as a
fit socket wrench) to bearing inner race.
(3) Push the ball bearing off the front cover us-
ing a press.
(D)
SC-00036
SC-00081
SC-00082