Subaru Legacy 2004 Service Manual page 678

FUEL INJECTION (FUEL SYSTEMS)
8) Tighten the bolts which install injector pipe on in-
take manifold.
• RH side
Tightening torque:
!
19 N m (1.9 kgf-m, 13.7 ft-lb)
• LH side
Tightening torque:
!
19 N m (1.9 kgf-m, 13.7 ft-lb)
9) Tighten the two bolts which install fuel pipes on
intake manifold.
Tightening torque:
!
6.4 N m (0.65 kgf-m, 4.7 ft-lb)
10) Install the engine harness onto intake manifold.
Intake Manifold
11) Tighten the bolts which install engine harness
on intake manifold.
Tightening torque:
16 N
FU-01098
12) Hold the engine harness by harness band clips.
13) Install the purge control solenoid valve. <Ref.
to EC(H4SO 2.0)-7, INSTALLATION, Purge Con-
trol Solenoid Valve.>
FU-01099
14) Install the tumble generator valve actuator.
(EC, EK and K4 model) <Ref. to FU(H4SO 2.5)-29,
INSTALLATION, Tumble Generator Valve Actua-
tor.>
15) Connect the connectors (A) to fuel injector.
16) Hold the engine harness to injector pipe by har-
ness band (B).
FU-01100
FU(H4SO 2.5)-18
!
m (1.6 kgf-m, 11.8 ft-lb)
(B)
(A)
FU-01097
FU-01096
FU-01336