Subaru Legacy 2004 Service Manual page 466

ENGINE (DIAGNOSTICS)
2. SUBARU SELECT MONITOR
1) After clearing the memory, check for any remain-
ing unresolved trouble data. <Ref. to EN(H4SO
2.0)(diag)-38, Clear Memory Mode.>
2) Idle the engine.
3) Prepare the Subaru Select Monitor kit. <Ref. to
EN(H4SO 2.0)(diag)-7, PREPARATION TOOL,
General Description.>
4) Connect the diagnosis cable to Subaru Select
Monitor.
5) Insert the cartridge to Subaru Select Monitor.
<Ref. to EN(H4SO 2.0)(diag)-7, PREPARATION
TOOL, General Description.>
6) Connect the test mode connector (A) located at
the lower portion of glove box.
Inspection Mode
EN-00038
EN-00039
(A)
EN-02424
EN(H4SO 2.0)(diag)-34
7) Connect the Subaru Select Monitor to data link
connector located in the lower portion of the instru-
ment panel (on the driver's side).
CAUTION:
Do not connect the scan tools except for Suba-
ru Select Monitor.
8) Turn the ignition switch to ON (engine OFF) and
turn Subaru Select Monitor switch to ON.
(A) Power switch
9) On the «Main Menu» display screen, select the
{Each System Check} and press the [YES] key.
10) On the «System Selection Menu» display
screen, select the {Engine} and press the [YES]
key.
11) Press the [YES] key after the information of en-
gine type has been displayed.
12) On the «Engine Diagnosis» screen, select the
{D Check} and press the [YES] key.
13) When the "Perform D Check?" is shown on the
screen, press the [YES] key.
14) Perform subsequent procedures as instructed
on the display screen.
• If trouble still remains in the memory, the corre-
sponding DTC appears on the display screen.
NOTE:
• For detailed operation procedure, refer to "SUB-
ARU SELECT MONITOR OPERATION MANUAL".
• For the details concerning DTCs, refer to "List of
Diagnostic Trouble Code (DTC)".
<Ref. to EN(H4SO 2.0)(diag)-66, List of Diagnostic
Trouble Code (DTC).>
• Release the parking brake.
EN-02533
(A)
EN-00040