Subaru Legacy 2004 Service Manual page 818

ENGINE (DIAGNOSTICS)
Step
1 CHECK OPTION CODE.
2 CHECK IGNITION SYSTEM FOR SPARKS.
1) Remove the plug cord cap from each spark
plug.
2) Install a new spark plug on plug cord cap.
CAUTION:
Do not remove the spark plug from engine.
3) Contact the spark plug's thread portion on
engine.
4) While opening the throttle valve fully, crank
the engine to check that spark occurs at each
cylinder.
3 CHECK POWER SUPPLY CIRCUIT FOR IG-
NITION COIL & IGNITOR ASSY.
1) Turn the ignition switch to OFF.
2) Disconnect the connector from ignition coil
& ignitor ASSY.
3) Turn the ignition switch to ON.
4) Measure the power supply voltage between
ignition coil & ignitor ASSY connector and
engine ground.
Connector & terminal
(E12) No. 2 (+) — Engine ground (
4 CHECK HARNESS OF IGNITION COIL & IG-
NITOR ASSY GROUND CIRCUIT.
1) Turn the ignition switch to OFF.
2) Measure the resistance between ignition
coil & ignitor ASSY connector and engine
ground.
Connector & terminal
(E12) No. 3 — Engine ground:
5 CHECK IGNITION COIL & IGNITOR ASSY.
1) Remove the spark plug cords.
2) Measure the resistance between spark
plug cord contact portions to check secondary
coil.
Terminals
No. 1 — No. 2:
No. 3 — No. 4:
Diagnostics for Engine Starting Failure
Is the option code EC, EK or
K4?
Does spark occur at each cyl-
inder?
Is the voltage more than 10 V? Go to step 4.
"
):
Is the resistance less than 5
'?
Is the resistance 10 — 15 k'? Go to step 6.
EN(H4SO 2.5)(diag)-62
Check Yes
Go to step 2.
Check fuel pump
system. <Ref. to
EN(H4SO
2.5)(diag)-64,
FUEL PUMP CIR-
CUIT, Diagnostics
for Engine Start-
ing Failure.>
Go to step 5.
No
Refer to EN(H4SO
2.0) section. <Ref.
to EN(H4SO
2.0)(diag)-66, List
of Diagnostic Trou-
ble Code (DTC).>
NOTE:
Fuel injection sys-
tem for KA and KS
model is the same
as 2.0 L model.
Go to step 3.
Repair the har-
ness and connec-
tor.
NOTE:
In this case, repair
the following:
• Open circuit in
harness between
ignition coil & igni-
tor ASSY and
main relay connec-
tor
• Poor contact in
coupling connector
• Blown out fuse
Repair the har-
ness and connec-
tor.
NOTE:
In this case, repair
the following:
• Open circuit in
harness between
ignition coil & igni-
tor ASSY connec-
tor and engine
grounding terminal
Replace the igni-
tion coil & ignitor
ASSY. <Ref. to
IG(H4SO 2.0)-8,
Ignition Coil & Igni-
tor ASSY.>