Subaru Legacy 2004 Service Manual page 96

19.CLUTCH FLUID
Check that the clutch fluid level is normal. If the
amount of fluid is insufficient, check that no leaks
are found. Then, add the necessary amount of
specified fluid.
(A) Reservoir tank
(B) MIN. level
(C) MAX. level
20.WINDOW WASHER FLUID
Check that the window washer fluid level is normal.
If the amount is insufficient, check that no leaks are
found. Then, add the necessary amount of washer
fluid.
21.FRONT HOOD LATCH CHECK
Retract the hood stay and close the front hood.
Check that the front hood is securely latched.
22.KEYLESS ENTRY SYSTEM
NOTE:
The following inspections show the initial settings.
When the settings are different from the initial set-
tings, use Subaru Select Monitor to check the de-
tails of each setting for inspections. <Ref. to
LAN(diag)-26, OPERATION, Read Current Data.>
1) Fully open all the door windows.
2) Remove the key from the ignition switch and
close all the doors including rear gate.
3) Press the "LOCK" or "UNLOCK" button on the
keyless transmitter 1 sec. or more and check if the
door window of driver seat is opened/closed.
Pre-delivery Inspection
(A)
(C)
(B)
PI-00173
PI-9
PRE-DELIVERY INSPECTION
4) Press the trunk open button (except for EK mod-
el) or "UNLOCK" button (EK model) for more than
one second. Check if the trunk is unlocked and the
hazard light flashes twice.
5) Press the "LOCK" button on the keyless trans-
mitter with the trunk lock opened. Check if the all
doors are locked, hazard light blinks five times and
warning shows trunk open.
6) Press the "LOCK" button momentarily on the
keyless transmitter. Check that all the doors are
locked and room light goes off.
PI-00174
PI-00196
PI-00175
PI-00108