Subaru Legacy 2004 Service Manual page 268

Tightening torque:
&
180 N m (18.4 kgf-m, 132.8 ft-lb)
3) Confirm that the tightening angle of crank pulley
bolt is 65 degrees or more. If the tightening angle of
crank pulley bolt is less than 65 degrees, conduct
the following procedures.
(1) Replace the crank pulley bolts and clean
them.
crank pulley bolt:
12369AA011
(2) Clean the crankshaft thread using com-
pressed air.
(3) Apply engine oil to the crank pulley bolt seal
and thread.
(4) Tighten the bolts temporarily with tightening
torque of 44 N&m (4.5 kgf-m, 33 ft-lb).
(5) Tighten the crank pulley bolts keeping them
in an angle between 65 degrees and 75 de-
grees.
NOTE:
Conduct the tightening procedures by confirming
the turning angle of crank pulley bolt referring to the
gauge indicated on timing belt cover.
4) Install the A/C belt tensioner.
5) Install the V-belt. <Ref. to ME(H4SO 2.0)-38, IN-
STALLATION, V-belt.>
C: INSPECTION
1) Make sure the V-belt is not worn or otherwise
damaged.
2) Check the tension of the belt. <Ref. to ME(H4SO
2.0)-39, INSPECTION, V-belt.>
Crank Pulley
ST ST
ME-00227
ME-00225
ME(H4SO 2.0)-41
MECHANICAL