Subaru Legacy 2004 Service Manual page 285

Tightening torque:
!
10 N m (1.0 kgf-m, 7.2 ft-lb)
( o )
( u )
( v )
( r )
(7) Tighten the bolts (w) and (x) in alphabetical
sequence.
Tightening torque:
!
10 N m (1.0 kgf-m, 7.2 ft-lb)
(w)
( x )
3) Apply a coat of grease to oil seal lips and install
the oil seal (A) on camshaft using ST1 and ST2.
NOTE:
Use a new oil seal.
ST1 499597000 OIL SEAL GUIDE
ST2 499587500 OIL SEAL INSTALLER
4) Install the plug using ST.
ST 499587700 CAMSHAFT OIL SEAL IN-
STALLER
5) Adjust the valve clearance. <Ref. to ME(H4SO
2.0)-29, ADJUSTMENT, Valve Clearance.>
6) Install the rocker cover and connect PCV hose.
7) Install the oil level gauge guide. (LH side only)
8) Install the camshaft position sensor support. (LH
side only)
( q )
( s )
( t )
( p )
ME-00270
ME-00271
ST1
ST2
( A )
ME-00272
ME(H4SO 2.0)-55
Camshaft
9) Install the tensioner bracket.
Tightening torque:
!
25 N m (2.5 kgf-m, 18.1 ft-lb)
10) Install the timing belt cover No. 2 (RH).
Tightening torque:
!
5 N m (0.5 kgf-m, 3.6 ft-lb)
11) Install the timing belt cover No. 2 (LH).
Tightening torque:
!
5 N m (0.5 kgf-m, 3.6 ft-lb)
12) Install the crank sprocket.
<Ref. to ME(H4SO 2.0)-50, INSTALLATION,
Crank Sprocket.>
13) Install the cam sprocket. <Ref. to ME(H4SO
2.0)-48, INSTALLATION, Cam Sprocket.>
14) Install the timing belt. <Ref. to ME(H4SO 2.0)-
44, INSTALLATION, Timing Belt.>
15) Install the timing belt cover.
<Ref. to ME(H4SO 2.0)-42, INSTALLATION, Tim-
ing Belt Cover.>
16) Install the crank pulley. <Ref. to ME(H4SO
2.0)-40, INSTALLATION, Crank Pulley.>
17) Install the V-belts. <Ref. to ME(H4SO 2.0)-38,
INSTALLATION, V-belt.>
MECHANICAL
ME-00273
ME-00274