Subaru Legacy 2004 Service Manual page 689

13.Tumble Generator Valve Ac-
tuator
A: REMOVAL
1. RH SIDE
NOTE:
This component is installed to EC, EK and K4 mod-
el.
1) Release the fuel pressure.
<Ref. to FU(H4SO 2.5)-40, RELEASING OF FUEL
PRESSURE, PROCEDURE, Fuel.>
2) Open the fuel filler flap lid and remove the fuel
filler cap.
3) Disconnect the ground cable from battery.
4) Remove the intake manifold.
<Ref. to FU(H4SO 2.5)-12, REMOVAL, Intake
Manifold.>
5) Disconnect the connector from tumble generator
valve RH.
6) Remove the tumble generator valve RH.
2. LH SIDE
1) Release the fuel pressure.
<Ref. to FU(H4SO 2.5)-40, RELEASING OF FUEL
PRESSURE, PROCEDURE, Fuel.>
2) Open the fuel filler flap lid, and remove the fuel
filler cap.
Tumble Generator Valve Actuator
IN-00203
FU-01108
FU(H4SO 2.5)-29
FUEL INJECTION (FUEL SYSTEMS)
3) Disconnect the ground cable from battery.
4) Disconnect the connector from tumble generator
valve LH.
5) Remove the tumble generator valve LH.
B: INSTALLATION
1. RH SIDE
Install in the reverse order of removal.
Tightening torque:
!
6 N m (0.61 kgf-m, 4.4 ft-lb)
2. LH SIDE
Install in the reverse order of removal.
Tightening torque:
!
6 N m (0.61 kgf-m, 4.4 ft-lb)
IN-00203
FU-01109