Subaru Legacy 2004 Service Manual page 258

(5) Generator connector and terminal
(A)
(B)
(A) Terminal
(B) Generator connector
(6) A/C compressor connectors
(7) Power steering switch connector
13) Disconnect the following hoses.
(1) Brake booster vacuum hose
(2) Heater inlet and outlet hoses
Engine Assembly
14) Remove the power steering pump from brack-
et.
(1) Loosen the lock bolt and slider bolt, and re-
move the front side belt. <Ref. to ME(H4SO
2.0)-38, FRONT SIDE BELT, REMOVAL, V-
belt.>
(2) Remove the power steering pump bracket.
ME-00818
(3) Place the power steering pump on the right
side wheel apron.
15) Remove the front and center exhaust pipe.
<Ref. to EX(H4SO 2.0)-7, REMOVAL, Front Ex-
haust Pipe.>
16) Remove the nuts which hold lower side of
transmission to engine.
ME-00819
17) Remove the nuts which install front cushion
rubber onto front crossmember.
FU-00878
18) Separate the torque converter clutch from drive
plate. (AT model)
(1) Lower the vehicle.
ME-00820
(2) Remove the service hole plug.
(3) Remove the bolts which hold torque con-
verter clutch to drive plate.
ME(H4SO 2.0)-31
MECHANICAL
FU-00139
ME-00210
LU-00223