Subaru Legacy 2004 Service Manual page 266

Tightening torque:
Lock nut (A);
&
23 N m (2.3 kgf-m, 17.0 ft-lb)
(B)
C: INSPECTION
1) Replace the belts, if cracks, fraying or wear is
found.
2) Remove the V-belt cover and reservoir tank.
(with belt tension gauge)
3) Check the V-belt tension and adjust it if neces-
sary by changing the generator installing position
or idler pulley installing position.
Belt tension (with belt tension gauge)
(A)
When installing new parts:
618 — 755 N (63 — 77 kgf, 139 — 170 lb)
At inspection:
490 — 640 N (50.0 — 65.3 kgf, 110.2 — 143.9
lb)
(B)
When installing new parts:
740 — 880 N (75.5 — 89.7 kgf, 166 — 198 lb)
At inspection:
350 — 450 N (35.7 — 45.9 kgf, 78.7 — 101.2
lb)
(A)
GEN
P/S
(A) Front side belt
(B) Rear side belt
C/P Crank pulley
GEN Generator
P/S Power steering oil pump pulley
A/C Air conditioning compressor pulley
I/P Idler pulley
(A)
ME-00224
A/C
(B)
I/P
C/P
PM-00154
ME(H4SO 2.0)-39
V-belt
Belt tension (without belt tension gauge)
(A)
When installing new parts:
7 — 9 mm (0.276 — 0.354 in)
At inspection:
9 — 11 mm (0.354 — 0.433 in)
(B)
When installing new parts:
7.5 — 8.5 mm (0.295 — 0.335 in)
At inspection:
9.0 — 10.0 mm (0.354 — 0.394 in)
P/S
(A) Front side belt
(B) Rear side belt
C/P Crank pulley
GEN Generator
P/S Power steering oil pump pulley
A/C Air conditioning compressor pulley
I/P Idler pulley
MECHANICAL
98 N (10 kg, 22 Ib)
A/C
GEN
(A) (B)
I/P
C/P
ME-00226