Subaru Legacy 2004 Service Manual page 705

6) Tighten the bolts which install the parking brake
cable clamp.
Tightening torque:
!
18 N m (1.8 kgf-m, 13.0 ft-lb)
Tightening torque:
!
32 N m (3.3 kgf-m, 23.9 ft-lb)
7) Connect the connector to rear ABS wheel speed
sensor.
8) Install the heat shield cover.
9) Install the propeller shaft. <Ref. to DS-11, IN-
STALLATION, Propeller Shaft.>
10) Install the rear exhaust pipe. <Ref. to EX(H4SO
2.0)-11, INSTALLATION, Rear Exhaust Pipe.>
11) Lower the vehicle.
12) Connect the parking brake cable to parking
brake assembly. <Ref. to PB-8, INSTALLATION,
Parking Brake Assembly (Rear Disc Brake).>
13) Install the rear brake caliper.
Fuel Tank
14) Tighten the bolt which secures rear brake hose
installation bracket.
Tightening torque:
33 N
FU-01130
15) Install the rear wheels.
16) Lower the vehicle.
17) Connect the connector (A) to fuel sub level sen-
sor.
18) Connect the quick connector to the fuel delivery
(B) and return hose (C). <Ref. to FU(H4SO 2.5)-
56, INSTALLATION, Fuel Delivery, Return and
Evaporation Lines.>
NOTE:
Be careful not to misconnect the delivery side and
return side.
FU-01131
19) Install the service hole cover of fuel sub level
sensor.
FU-01129
FU(H4SO 2.5)-45
FUEL INJECTION (FUEL SYSTEMS)
!
m (3.4 kgf-m, 25 ft-lb)
(A)
(B)
(A)
(A) Bolt
(B) Grommet
FU-01128
(C)
FU-01127
(A)
(B)
FU-01126