Subaru Impreza 2002 Service Manual page 3266

AIRBAG CONTROL MODULE
AIRBAG SYSTEM
7. Airbag Control Module
A: REMOVAL
CAUTION:
• Do not disassemble the airbag control mod-
ule.
• If the airbag control module is deformed or if
water damage is suspected, replace the airbag
control module with a new genuine part.
• Do not drop the airbag control module.
• After removal, keep the airbag control mod-
ule on a dry, clean surface away from moisture,
heat, and dust.
1) Turn the ignition switch to OFF.
2) Disconnect the ground cable from battery, and
wait for at least 20 seconds before starting work.
3) Remove the console box. <Ref. to EI-40, RE-
MOVAL, Console Box.>
4) Disconnect the connector from airbag control
module.
®
5) Using the T40 TORX bit (Tamper resistant
®
type), remove the four TORX bolts in the order
shown in the figure.
RE0001
RE0001
B: INSTALLATION
CAUTION:
®
Use new TORX bolts during re-assembly.
Install in the reverse order of removal.
C: INSPECTION
Check for the following, and replace damaged
parts with new parts.
• Control module, connector, and mounting brack-
et are damaged.
• Airbag is deployed.
• Side airbag is deployed.
AB-15