Subaru Impreza 2002 Service Manual page 3427

Hide thumbs Also See for Impreza 2002:

Table of Contents

WIPER AND WASHER SYSTEMS

10.Rear Wiper Motor

1) Disconnect the ground cable from battery.

2) Remove the rear wiper arm.

3) Remove the cap (A), nut (B), and spacer (C)

from rear wiper shaft.

4) Remove the rear gate lower trim. <Ref. to EI-50,

REMOVAL, Rear Gate Trim.>

5) Unclip the clip of harness and disconnect the

connector of wiper motor.

6) Loosen the bolts to remove the wiper motor as-

B: INSTALLATION

1) Install in the reverse order of removal.

2) Install the rear wiper cushion with the arrow

mark facing up, as shown in the figure.

Tightening torque:

Refer to COMPONENT in General Descrip-

<Ref. to WW-3, REAR WIPER, COMPONENT,

General Description.>

REAR WIPER MOTOR

C: INSPECTION

1) Connect the battery to wiper motor connector

and confirm that the wiper motor operates.

2) Connect the battery to terminal of connector and

remove the terminal connections with motor rotat-

ed, and stop the wiper motor through operation.

3) Connect the battery and confirm that the motor

stops at automatic stop position after the motor op-

erates at low speed again.

Show Quick Links

Chapters

Table of Contents