Subaru Impreza 2002 Service Manual page 3423

WIPER AND WASHER SYSTEMS
7. Front Wiper Motor and Link
A: REMOVAL
NOTE:
The positions for RHD model are symmetrically op-
posite.
1) Disconnect the ground cable from battery.
2) Remove the cowl panel. <Ref. to EI-32, RE-
MOVAL, Cowl Panel.>
3) Disconnect the connector of motor.
4) Loosen the bolts and nuts to remove wiper link.
5) Loosen the bolts and nuts to remove motor.
B: INSTALLATION
1) Connect the battery ground cable to battery.
2) To confirm that the motor is at auto stop position,
connect the harness to motor and turn the wiper
switch ON/OFF once.
3) Disconnect the ground cable from battery.
4) Tighten the nut where rod (A) and link plate (B) is
aligned in a straight line.
FRONT WIPER MOTOR AND LINK
B5M1466
B5M1467
BO0274
WW-14
5) Install in the reverse order of removal.
Tightening torque:
Refer to COMPONENT in General Descrip-
tion.
<Ref. to WW-2, FRONT WIPER,
COMPONENT, General Description.>
C: INSPECTION
1) When the battery is connected to the terminal of
connectors, confirm that motor operates at low
speed.
2) When the battery is connected to the terminal of
connectors, confirm that motor operates at high
speed.
3 2
3) Connect the battery to terminals of connector,
and remove the terminal connection with motor ro-
tated at low speed, and stop the wiper motor
through operation.
3 2 1
5 4
BO0201
1
5 4
BO0202
3 2 1
5 4
BO0203