Subaru Impreza 2002 Service Manual page 3403

LIGHTING SYSTEM
23.High-mounted Stop Light
A: REMOVAL
1. SEDAN (STANDARD TYPE)
1) Disconnect the ground cable from battery.
2) Disconnect the connector of high-mounted stop
light from body harness.
3) Remove the bolts, then detach the high-mount-
ed stop light assembly.
2. SEDAN (REAR SPOILER BUILT-IN
TYPE)
1) Disconnect the ground cable from battery.
2) Remove the bolts, then detach the high-mount-
ed stop light assembly.
3) Disconnect the connector of high-mounted stop
light from body harness.
HIGH-MOUNTED STOP LIGHT
B5M0816
BO0028
LI-26
3. WAGON
1) Disconnect the ground cable from battery.
2) Remove the cap (a) by prying on the edge with
screwdriver.
3) Remove the screws (b), and then the detach
cover (c).
4) Remove screws (d), and then detach the high-
mounted stop light while disconnecting connector.
B: INSTALLATION
Install in the reverse order of removal.
C: INSPECTION
1) Visually check the bulb for blow out.
2) Check the bulb specification. <Ref. to LI-2,
SPECIFICATIONS, General Description.>
3) If NG, replace the bulb with a new one.
B6M1343A