Subaru Impreza 2002 Service Manual page 3076

13) Remove the clamp bolts securing gearbox to
crossmember, and then remove the gearbox.
(1) Clamp
B: INSTALLATION
1) Insert the gearbox into crossmember, being
careful not to damage the gearbox boot.
2) Tighten the gearbox to crossmember bracket via
clamp with bolt to the specified torque.
Tightening torque:
59 N·m (6.0 kgf-m, 43.4 ft-lb)
(1) Clamp
3) Install the four pipes on gearbox.
(1) Connect the pipes A and B to four pipe joints
of gearbox. Connect the upper pipe B first, and
lower pipe A.
Tightening torque:
13 N·m (1.3 kgf-m, 9.4 ft-lb)
STEERING GEARBOX [LHD MODEL]
S4M0383A
S4M0383A
PS-33
POWER ASSISTED SYSTEM (POWER STEERING)
(2) Connect the pipes C and D to gearbox.
Connect the upper pipe D first, and lower pipe C
second.
Tightening torque:
15 N·m (1.5 kgf-m, 10.8 ft-lb)
(1) Pipe C
(2) Pipe D
4) Install the universal joint. <Ref. to PS-27, IN-
STALLATION, Universal Joint.>
5) Connect the tie-rod end and knuckle arm, and
tighten with castle nut. Fit the cotter pin into nut and
bend the pin to lock.
Castle nut tightening torque:
Tighten to 27 N·m (2.75 kgf-m, 19.9 ft-lb), and
tighten further within 60 ° ° ° ° until cotter pin hole
is aligned with a slot in the nut.
CAUTION:
When connecting, do not hit the cap at bottom
of tie-rod end with hammer.
(1) Castle nut
(2) Tie-rod end
(3) Knuckle arm
6) Install the front stabilizer to vehicle.
7) Install the front exhaust pipe assembly.
8) Install the sub frame. <Ref. to FS-25, REMOV-
AL, Sub Frame.>
S4M0382A
S4M0379A