Subaru Impreza 2002 Service Manual page 3098

20) After adjusting the toe-in and steering angle,
tighten the lock nut on tie-rod end.
Tightening torque:
83 N·m (8.5 kgf-m, 61.5 ft-lb)
CAUTION:
When adjusting the toe-in, hold boot as shown
to prevent it from being rotated or twisted. If
twisted, straighten it.
C: DISASSEMBLY
1) Secure the gearbox removed from vehicle in
vise using the ST.
ST 926200000 STAND
CAUTION:
Secure the gearbox assembly in a vise using
the ST as shown. Do not attempt to secure it
without this ST.
(1) Clamp
2) Remove the tie-rod end plate.
STEERING GEARBOX [RHD MODEL]
G4M0132
S4M0388A
ST0084
PS-55
POWER ASSISTED SYSTEM (POWER STEERING)
3) Remove the tie-rod end and lock nut from gear-
box.
4) Pry off the clip from outer end of boot, and the
slide the boot toward tie-rod end.
(1) Clip
5) Using standard screwdriver, remove the band
from boot.
(1) Band
6) Extend the rack approx. 40 mm (1.57 in) out. Un-
lock the lock wire at lock washer on each side of tie-
rod end using a standard screwdriver.
CAUTION:
Be careful not to scratch the rack surface as oil
leaks may result.
S4M0389A
S4M0145C
G4M0791