Subaru Impreza 2002 Service Manual page 3003

BRAKE
10.Rear Drum Brake Assembly
A: REMOVAL
1) Loosen the wheel nuts, jack-up the vehicle, sup-
port it with rigid racks, and remove the wheel.
2) Release the parking brake.
3) Remove the brake drum from brake assembly.
<Ref. to BR-43, REMOVAL, Rear Drum Brake
Drum.>
4) Remove the brake shoe. <Ref. to BR-41, RE-
MOVAL, Rear Drum Brake Shoe.>
5) Unscrew the brake hose flare nut and discon-
nect brake hose.
6) Remove the hub.
<Ref. to DS-24, REMOVAL, Rear Axle.>
7) Disconnect the ABS sensor from back plate.
(only vehicle equipped ABS)
8) Remove the brake assembly.
9) Remove the bolts installing wheel cylinder on
back plate, and remove it.
REAR DRUM BRAKE ASSEMBLY
BR0104
G4M0400
S4M0454
BR-44
B: INSTALLATION
1) Clean the back plate and wheel cylinder.
2) Install the wheel cylinder on back plate, and
tighten bolts.
Tightening torque:
10 N·m (1.0 kgf-m, 7.2 ft-lb)
3) Apply grease to the portions indicated by arrows
in the figure.
Brake grease:
Dow Corning Molykote No. 7439 (Part No.
725191460)
S4M0454
G4M0407