Subaru Impreza 2002 Service Manual page 3474

B: INSTALLATION
1) Clean the external circumference of windshield
glass with alcohol or white gasoline.
2) Remove the adhesive layer on the body using
cutter knife to obtain smooth face 2 mm (0.08 in)
thick.
CAUTION:
Be careful not to damage the body and paint
surface.
3) Clean the body with alcohol or white gasoline to
remove thoroughly chips, dusts, and dirts from
body face.
4) Place the glass on body.
5) Adjust the glass position to make uniform clear-
ance between body and glass in four corners.
6) Place the matching pins and body on glass.
Matching pin
Dam rubber
11 (0.433)
Unit: mm (in)
7) Remove the glass from body.
WINDSHIELD GLASS
G5M0553
11 (0.433)
Fastener
15 (0.591)
BO0395
GW-27
8) Fit the molding mark (B) to notch (A).
9) Apply primer to the adhesive layer of glass using
sponge.
10) Apply primer to the adhesive layer of body.
CAUTION:
• Primer once attached to the painted surface
of the body and internal trim is hard to wipe off.
Mask the circumference of such areas.
• Let the primer dry for about ten minutes be-
fore installing the glass.
• Do not touch the surface coated with primer.
GLASS/WINDOWS/MIRRORS
BO0270
G5M0495