Subaru Impreza 2002 Service Manual page 3024

19.Brake Pedal
A: REMOVAL
1. LHD 1.6 L MT MODEL
1) Disconnect the ground cable from battery.
2) Disconnect the clutch cable from release lever.
3) Remove the instrument panel lower cover from
instrument panel.
4) Disconnect the following parts from pedal brack-
et.
• Operating rod of brake booster
• Electrical connectors (for stop light switch, etc.)
5) Remove the clevis pin which secures pedal to
push rod.
6) Remove the bolts and nuts which secure brake
and clutch pedals, and remove the pedal bracket
and clutch cable as a unit.
CAUTION:
Before removing the clutch cable from toe
board, remove the grommet. Slowly remove the
clutch cable, being careful not to scratch it.
(A)
(A) Clutch pedal
(B) Brake pedal
7) Depress the clutch pedal, disconnect the clutch
cable from clutch pedal.
BRAKE PEDAL
2. LHD 2.0 L MT MODEL
1) Remove the steering bolts.
2) Raise the vehicle on hoist and remove the two
bolts which secure steering unit to underside of
body.
3) Lower the vehicle to floor.
4) Remove the instrument panel lower cover from
instrument panel.
5) Disconnect the following parts from pedal brack-
et.
• Operating rod of brake booster
• Electrical connectors (for stop light switch, etc.)
6) Remove the clevis pin which secures lever to
push rod.
7) Remove the nut which secures clutch master
cylinder.
8) Remove the steering assembly.
9) Remove the accelerator pedal.
10) Remove the bolts and nuts which secure pedal
bracket.
3. AT MODEL AND RHD MT MODEL
1) Disconnect the ground cable from battery.
2) Remove the instrument panel lower cover from
instrument panel.
3) Remove the clevis pin which secures brake ped-
al to brake booster operating rod. Also disconnect
the stop light switch connector.
(B)
4) Remove the two bolts and four nuts which se-
cure the brake pedal to pedal.
TR0494
BR-65
BRAKE
BR0075
G4M0324