Subaru Impreza 2002 Service Manual page 3461

GLASS/WINDOWS/MIRRORS
6) Adjust so that the upper and lower ends of cen-
ter pillar are the same size.
7) For glass stroke adjustment, close the door,
raise glass until positional relationship between
glass and weatherstrip becomes as shown. And
secure the glass so that the upper stopper lightly
touches the glass holder.
A
A
Unit: mm (in)
For preventing wind noise, adjust the glass at the
position where tip of gusset is raised up a little.
(A) 0-1.5 mm (0-0.059 in)
FRONT DOOR GLASS
BO0389
2-3
(0.079-0.118)
6 (0.236)
BO0267
BO0390
8) After stabilizer adjustment, carry out the glass
crimp adjustment. First, visually ensure positional
relationship between retainer & molding and glass
of the roof side, and then begin with rear sash ad-
justment. Adjust two adjusting bolts alternately step
by step to obtain dimensions shown below (cross-
section A).
NOTE:
If two nuts are loosened at the same time, sash
moves back and forth. Therefore, when one nut is
adjusted, secure the other.
9) Make the same adjustment of two adjusting bolts
of rear sash.
Unit: mm (in)
CAUTION:
Do not tilt the sash bracket to inner panel dur-
ing adjustment. Otherwise smooth regulator
operation cannot be achieved.
10) Make adjustment of front sash in the same
manner as that of rear sash.
CAUTION:
Although front and rear sashes must, as a rule,
be adjusted in the same manner, in some door
installation, the adjustment in a different man-
ner may be required. However, adjustment of
one sash to the maximum amount and the other
to the minimum amount is not permitted. Such
adjustment may result in application of exces-
sive load to regulator.
GW-14
2-3
(0.079-0.118)
A
A
6 (0.236)
BO0267
S5M0201A