Subaru Impreza 2002 Service Manual page 3754

2. Working Precautions
A: PRECAUTIONS WHEN WORKING
WITH THE PARTS MOUNTED ON
THE VEHICLE
1) When working under a vehicle which is jacked-
up, always be sure to use safety stands.
2) The parking brake must always be applied dur-
ing working. Also, in automatic transmission vehi-
cles, keep the select lever set to P (Parking) range.
3) Be sure the workshop is properly ventilated
when running the engine. Further, be careful not to
touch the belt or fan while the engine is operating.
4) Be careful not to touch hot metal parts, especial-
ly the radiator and exhaust system immediately af-
ter the engine has been shut off.
B: PRECAUTIONS IN TROUBLE DI-
AGNOSIS AND REPAIR OF ELEC-
TRIC PARTS
1) The battery cable must be disconnected from
battery's (−) terminal, and the ignition switch must
be set to OFF position, unless otherwise required
by the diagnostics.
2) Securely fasten the wiring harness with clamps
and slips so that the harness does not interfere with
body end parts or edges and bolts or screws.
3) When installing the parts, be careful not to catch
them on the wiring harness.
4) When disconnecting a connector, do not pull the
wires, but pull while holding the connector body.
WORKING PRECAUTIONS
5) Some connectors are provided with a lock. One
type of such a connector is disconnected by push-
ing the lock, and the other, by moving the lock up.
In either type the lock shape must be identified be-
fore attempting to disconnect the connector.
To connect, insert the connector until it snaps and
confirm that it is tightly connected.
6) When checking continuity between connector
terminals, or measuring the voltage across the ter-
minal and ground, always contact tester probe(s)
on terminals from the wiring connection side. If the
probe is too thick to gain access to the terminal, use
"mini" test leads.
To check water-proof connectors (which are not ac-
cessible from the wiring side), contact test probes
on the terminal side being careful not to bend or
damage terminals.
G6M0212
7) Sensors, relays, electrical unit, etc., are sensi-
tive to strong impacts.
Handle them with care so that they are not dropped
or mishandled.
WI-15
WIRING SYSTEM
G6M0213
G6M0214