Subaru Impreza 2002 Service Manual page 3480

17.Rear Quarter Glass
A: REMOVAL
Remove the glass in the same procedure as for windshield glass. <Ref. to GW-26, REMOVAL, Windshield
Glass.>
B
B
A
A
A-A
Dam rubber
Adhesive
B: INSTALLATION
1) Cut off the nozzle tip as shown in the figure.
2) Install the glass in the same procedure as for
windshield glass. <Ref. to GW-27, INSTALLA-
TION, Windshield Glass.>
CAUTION:
• When the door is opened/closed after glass is
bonded, always lower the door glass and then
open/close it carefully.
• Move the vehicle slowly.
REAR QUARTER GLASS
Matching pin
C
C
Rear quarter glass
Molding
G5M0414
GW-33
C-C
Matching pin
Adhesive
Molding
B-B
Molding
Rear quarter glass
3) After completion of all work, allow the vehicle to
stand for about 24 hours.
NOTE:
For minimum drying time and time the vehicle must
be left standing before driving after bonding, follow
instructions or instruction manual from the adhe-
sive manufacturer.
4) After curing of adhesive, pour water on external
surface of vehicle to check that there are no water
leaks.
CAUTION:
When a vehicle is returned to the user, tell him
or her that the vehicle should not be subjected
to heavy impact for at least three days.
GLASS/WINDOWS/MIRRORS
Rear gate glass
Molding
Rear quarter glass
Adhesive
Matching pin
BO0210