Subaru Impreza 2002 Service Manual page 2982

6) Use a wrench to expand the pads, then push the
piston back.
7) Remove the pad.
B: INSTALLATION
1. 14 INCH AND 15 INCH TYPE
1) Apply thin coat of Molykote AS880N (Part No.
26298AC000) to the frictional portion between pad
and pad clip.
2) Apply thin coat of Molykote AS880N (Part No.
26298AC000) to the frictional portion between pad
and pad inner shim.
3) Install the pads on support.
4) Install the caliper body on support.
Tightening torque:
37 N·m (3.8 kgf-m, 27.5 ft-lb)
NOTE:
If it is difficult to push the piston during pad replace-
ment, loosen the air bleeder to facilitate work.
FRONT BRAKE PAD
2. 16 INCH TYPE
1) Apply thin coat of Molykote AS880N (Part
No.26298AC000) to the frictional portion between
pad and pad inner shim.
H4M1370
2) Install the pads on caliper body.
3) Install the pad pins on caliper body.
4) Install the M clip.
5) Install the cross spring.
C: INSPECTION
1. 14 INCH AND 15 INCH TYPE
Check the pad thickness A.
H4M1371
Pad thickness
(including back
metal)
CAUTION:
• Always replace the pads for both right and
left wheels at the same time. Also replace the
pad clips if they are twisted or worn.
• A wear indicator is provided on the inner disc
brake pad. If the pad wears down to such an ex-
B4M1169A
tent that the end of wear indicator contacts disc
rotor, a squeaking sound is produced as the
wheel rotates. If this sound is heard, replace the
pad.
• Replace the pad if there is oil or grease on it.
BR-23
BR0008
B4M1168A
Standard value 17 mm (0.67 in)
Wear limit 7.5 mm (0.295 in)
BRAKE