Subaru Impreza 2002 Service Manual page 3090

(6) Tighten the adjusting screw.
Tightening torque:
First; 7.4 N·m (0.75 kgf-m, 5.4 ft-lb)
Second; Back off 25 ° ° ° °
(7) Install the lock nut. While holding adjusting
screw with a wrench, tighten the lock nut using
ST.
ST 926230000 SPANNER
Tightening torque (Lock nut):
39 N·m (4.0 kgf-m, 28.9 ft-lb)
NOTE:
• Hold the adjusting screw with a wrench to pre-
vent it from turning while tightening lock nut.
• Make adjustment so that the steering wheel can
be rotated fully from lock to lock without binding.
21) Check for service limit as per article of "Service
limit".<Ref. to PS-49, SERVICE LIMIT, INSPEC-
TION, Steering Gearbox [LHD MODEL].> Make re-
placement and adjustment if necessary.
22) Take off the gearbox from ST.
23) Install the four pipes on gearbox.
(1) Connect the pipe A and B to the gearbox.
Tightening torque:
13 N·m (1.3 kgf-m, 9.4 ft-lb)
(2) Connect the pipe E and F to gearbox.
Tightening torque:
Pipe E: 15 N·m (1.5 kgf-m, 10.8 ft-lb)
Pipe F: 25 N·m (2.5 kgf-m, 18.1 ft-lb)
STEERING GEARBOX [LHD MODEL]
PS-47
POWER ASSISTED SYSTEM (POWER STEERING)