BRAKE
2. REAR BRAKE HOSE
1) Pass the brake hose through hole of bracket,
and lightly tighten the flare nut to connect brake
pipe.
2) Insert the clamp upward to fix brake hose.
3) While holding the hexagonal part of brake hose
fitting with a wrench, tighten the flare nut to the
specified torque.
Tightening torque (Brake pipe flare nut):
15 N·m (1.5 kgf-m, 10.8 ft-lb)
(1) Brake hose clamp
(2) Brake hose
(2) Brake pipe
4) Bleed air from the brake system.
C: INSPECTION
Ensure there are no cracks, breakage, or damage
on the hoses. Check the joints for fluid leakage. If
any cracks, breakage, damage or leakage is found,
repair or replace the hose.
BRAKE HOSE
BR0068
BR-60